Roof Board
Installation Guide

Product Description

saveBOARD roofBOARD is an engineered roof cover board, made from 99% recycled composite packaging waste with a fibreglass facing that is a sustainable alternative to traditional building materials. No glues, resin or additives are used in our process to create a product that is rated for extreme wind lift, fire resistant, superior compressive strength and is moisture and mould resistant.

​

Installation Instructions:

• Contact membrane manufacturer/roofing designer for combability, installation and fastening density to meet their product requirements.

• saveBOARD will not be responsible: for specific building and roof design; for deficiencies in construction or workmanship; for dangerous conditions on the jobsite; or, for improper storage and handling. Technical specifications shown in this literature are intended to be used as general guidelines only and are subject to change without notice.

• For cutting saveBOARD, use a circular saw is recommended with at least 40 teeth.

• Always wear appropriate PPE-approved safety gear.

• Material Safety Data sheet available on the website (Technical Literature).

​

Storage Instructions

• Do not store any saveBOARD products outside without a waterproof cover. Even if intended for external use, while on the pallet, water will migrate between the layers making the backing paper wet and degrade the products prior to installation.

• Membrane Roof Systems, or a qualified engineer, to ensure proper moisture control and ventilation.

​

For more information refer to our website: www.saveBOARD.nz or www.saveBOARD.com.au